![]() ![]() You can now click on the top left of the VISA menu and pin it or future use.ģ. Drag and drop the ‘Open’ and ‘Close’ VIs to your block diagram: Right click on the block diagram, select Instrument I/O->VISA->Advanced: We chose to demonstrate using USB.Ģ. Once the LabVIEW is up and running, open a new blank VI: Press Enter to select the active Interface you need. To do so, go to: “Utility”->”Remote Interface”->”Select Interface”->”Control from Interface”. To connect and control the Tabor Instrument using SCPI Commandsġ. Set the USB/LAN/GPIB as the remote interface, using the Tabor’s front panel buttons.Also please go over the connectivity tutorials on the Tabor’s website. To ensure you successfully established all the necessary settings for remote control over the Tabor instrument using LAN/USB/GPIB, please make sure you have already installed the latest NI-VISA from the National Instruments website. SCPI commands are an ASCII-based set of commands for reading and writing instrument settings.įor this tutorial, we will use LabVIEW 2015 32bit and a Tabor WX2184C using USB interface. In this tutorial, we will give a quick start guide on how you can communicate with the Tabor AWG using NI-VISA to send Standard Commands for Programmable Instruments (SCPI). Relevant Documents Download article (1668KB) ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |